Hydraulic press is the use of traditional press and modern technology combined with the combination of modern oil press, with high efficiency, environmental protection and energy saving, high value-added products, no loss, no noise, physical compression without heating, do not add any chemical raw materials , No oil, easy to operate, no wearing parts, long service life. Hydraulic Oil Press Hydraulic press is the biggest advantage of the equipment pressure is static pressure, oil mechanical friction is very small, Hydraulic Oil Press squeezed out of the oil is very clear, do not need to do any treatment can be directly consumed, convenient and safe. That the equipment has a high pressure high temperature press oil, almost can be out of oil can be pressed oil.
There is a cylinder on the base of the hydraulic press, and the cylinder is equipped with a cylindrical piston, and the upper part of the piston is integrated with the disc. The billet is pre-pressed into a round cake, and the outer jacket is folded between 20 and 40 rounds of cake between the cake and the roof, Hydraulic Oil Press and the cake and the cake are separated by a perforated thin plate to drive the top of the piston, Produce pressure, squeeze the cake out of oil. After pressing the pump to stop the pressure, the piston down, the slag unloaded, re-loaded with cake, as a result of repeated intermittent oil, each pressing about 2 to 5 hours. In the use of electric oil pump can be composed of circulating oil system, while operating several hydraulic press operation. Horizontal hydraulic press structure and working principle and vertical basically the same, the equipment is easy to install, smooth flow of oil, oil cake circle is not accumulated oil; but covers an area of large, need to be equipped with the back of the heavy hammer, Hydraulic Oil Press pulley Or screw mechanism. Hydraulic press pressure, a high oil rate, less moving parts, easy maintenance; but the loading and unloading of labor intensity is also larger.
Hydraulic press models are: a press 9kg / 13kg / 17kg.
The machine is mainly composed of three parts: 1, the main body 2, transmission hydraulic 3, electrical control 1. The main body part: it is by the floor, column, on the board, squeeze the soup assembly, then oil pan, nuts, etc. The composition of the parts is one of the main parts of the machine, Hydraulic Oil Press in which the oil is pushed up by the action of the cylinder assembly, and the oil flows down from the oil sump, 2. Transmission hydraulic part: This is the main production of high oil rate of the main power source, it is by the drive shaft, worm, worm, gear pump, high pressure pump, relief valve, manual valve, cylinder assembly, And other parts. 3. Electrical control part: it consists of motor, voltmeter, temperature control table, pressure gauge, power and other components.